CAMSHAFT POSITION SENSOR TOYOTA AVANZA

CAMSHAFT POSITION SENSOR Toyota Avanza HOW TO CHANGE THE POSITION SENSOR CAMSHAFT Toyota Avanza

Actually, to replace the camshaft position sensor accuracy is not hard just need it if do not believe try to follow these directions:
#OFF THE CABLE FROM NEGATIVE BATTERY TERMINAL
#OFF AIR FILTER ASSEMBLY

1.Disconnect the inlet air temperature sensor connector.
2.Disconnect the VSV connector.
3.Remove the charcoal canister hose No. outlet. 2.
4.Remove the hoses from VSV.

5.Unplug the vacuum sensor.
6.Disconnect vacuum hose from the sensor.

7.Separate reserve tank hose from the air filter hose clamps.
8.Remove the four bolts, then remove the air filter and air filter hose.

#OFF POSITION SENSOR CAMSHAFT Toyota Avanza
Disconnect the camshaft position sensor connector.Remove the bolt and the camshaft position sensor

#CHECK THE POSITION SENSOR CAMSHAFT Toyota Avanza
 How do I check the CAMSHAFT POSITION SENSOR Toyota Avanza damage by examining the prisoner, using the ohmmeter which you can measure the resistance on any terminal that is on the CAMSHAFT POSITION SENSORPrisoners standard that we measure by connecting the tester to the terminals 1 (+) - 2 (-) so that the obtained results penggukuran 1850 to 2450 Ω at 20 ° C (68 ° F)If the results are not in accordance with the specification, replace the camshaft position sensor.

#POST POSITION SENSOR CAMSHAFT Toyota Avanza
 How to mount POSITION SENSOR camshaft that had you off, follow these steps:Before you apply a thin-mounted engine oil to the O-ring, and install a camshaft position sensor with the bolt. Where monen pengencangannya is 7.5 N * m {76 kgf * cm, 66 in .* lbf}

Finally connect the camshaft POSITION SENSOR
CAUTION:
Ensure that the O-ring is not cracked or pinched during installation.


#POST AIR FILTER ASSEMBLY
1.Replace the air filter and air filter hose with 4 bolts.Occasion:7.5 N * m {76 kgf * cm, 66 in .* lbf}
2.Attach a hose to the reserve tank air filter hose clamps.
3.Connect the hose to the VSV.
4.Connect the charcoal canister hose outlet No. 2.
5.Connect the vacuum hose to the vacuum sensor.
6.Connect the vacuum sensor.
7.Connect the VSV connector.
8.Connect the intake air temperature sensor connector.


#CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


#CHECK ENGINE OIL LEAK 
Once installed try to power up and check for oil leaks on the engine camshaft POSITION SENSOR
All New Avanza & The All New Avanza Veloz