Custom Search

Monday, December 03, 2012

USE OF ALARM SYSTEM TOYOTA RUSH

USE OF ALARM SYSTEM TOYOTA RUSH
 
Wireless remote control system is designed to lock or unlock all locks and side door or back door alarm activate within about 10 m of the vehicle (without a hitch).

 When you operate any switch, press it slowly and correctly. At this time the indicator light will light up when pressed (answerback).Remote control is an electronic component. Consider the following guidelines in order not to cause damage to the remote control.

    .
Do not leave the key in a very high temperature such as above the dashboard.
    .
Do not disassemble.
   
.Avoid collisions against other objects or severe fall.
   
.Avoid wet conditions or dropped / submerged into the water.
You can use up to four remote control for the same vehicle. Contact your Toyota dealer for detailed information.If you can not move the remote control doors or alarm, or can not be operated from a distance of normal or lock indicator lights on dim or does not illuminate, then:

    1.
Check if adjacent transmitters such as radio stations or airports that may affect the normal remote control.


Tip: if this happens, hold the remote control on the windshield of the driver, and then press the remote control switch for ± 3 seconds or until the lock or unlock central lock.

    2.
The battery may have been empty, check the batteries in the remote control.


If you lose your remote control, contact your Toyota dealer to avoid the possibility of theft or an accident.


Locking and unlocking doorsTo lock and unlock all the side doors and back door, press the switch key slowly and correctly.Locking the doors with the remote control will activate the alarm system and the release of the key will disable the alarm system.


 Lock and unlock the alarm 

Press the switch LOCK and make sure all of the side door and the rear door is closed. All the side doors and back door will lock simultaneously. At that time, the two indicators will appear as follows.

· Turn signal lamps flash once.· The horn will sound once. 


Check to determine that all of the side door and the rear door is securely locked.

To find out if there is one door or the hood is not closed completely, consider the following indicators.


If the door is still open / not meeting: the horn will sound 5 times, turn signal lights flash once and the LED alarm indicator flashes 3 times - 3 times onwards.


If the hood is open / not meeting: the horn will sound 5 times, turn signal lights flash once and the LED alarm indicator flashes 1 time - 1 times onwards.


If the switch LOCK is pressed when the ignition key is in position "Lock or ACC, central lock will lock and the alarm is active.


If the switch LOCK is pressed when the key is in the ignition to "ON, the central lock will lock but the alarm will not be active.


If the alarm has been activated

 When the alarm system detects abnormalities will display the following indicators.

   1.
When the sensor gets moderate impact, the alarm will sound a warning horn 10 times teputus-off and turn signal lights flash twice.

   2.
Sensor got concussion. *

   3.
One of the doors or the hood is opened by force. **

   4.Switch
ignition is turned to "ON".

   5.
Battery terminals or circuits connected to the ECU and then released again.


* Alarm will only receive vibration 3 times in 1 hour, 4 vibration to be ignored and normal again after 1 hour. This is to avoid any conflict of continuous false.


**Rings for 30 seconds if a door is opened and then closed again, and if the door is opened the alarm will continue to sound for 30 seconds times 3.

 
If the battery is empty 


When the battery is recharged or replaced, the system will sound an alarm. To unsubscribe from the alarm press the switch UNLOCK the alarm stops.

Lock and unlock the alarm without sound (silent mode)

Done within 3 seconds.

Press the switch SIRINE and press LOCK it all the side doors and back door will lock simultaneously. Turn signal lamps flash once.


Description: make sure that all doors are closed tightly because there is no warning.

 Opening and disabling alarms
 Press the switch LOCK then all the side doors and back door will open simultaneously. At this time, there will be an indicator as follows.· Turn signal lights blink 2 times.· The horn will sound 2 times.· LED indicator does not light. ** If the alarm LED indicator flashes, it is to notice that the alarm had sounded and to determine the source of the sound see table.

Opening and deactivate alarm without sound (silent mode)

 Done within 3 seconds.Press the switch SIRINE  and press UNLOCK it all side doors and rear doors open simultaneously. Turn signal lights flash twice.

Active system and lock the doors automatically (auto re-arm / re-lock) 


The alarm is activated and the central lock will lock after 30 seconds, starting after we disable the alarm via the remote control but no doors are opened.
DIAGNOSTIC TABLE 

TOTAL LED FLICKER                  HAS HAPPENED TO INTERFERENCE
1............................................  Have opened the hood 

2............................................  Has opened one of the doors.
3............................................  Got louder clash 
4............................................  Additional sensors (if equipped) 
5............................................  Once the ignition key in the "ON" 

LED will automatically return to normal when the ignition key in turn to the "ON"

Ring the alarm (panic mode)

 Pressing the switch SIRINE  for 2 seconds or more vehicles honking intermittently and turn signal lights and interior lights to blink.

This function is used to deter theft of the vehicle when you see there are people trying to smash a window or damaging your vehicle.


Alarm will sound sub 30 seconds. To turn off the alarm before the 30 seconds press the switch SIRINE.Panic mode still works when the ignition key is in position "ON".

 
Disabling an emergency (no remote control) 


 At the time of an active alarm and the siren went off while the remote control is not working conditions.

The alarm can be stopped by means of: turn the ignition from ACC to ON-OFF 10 times the siren will stop.

All New Avanza & The All New Avanza Veloz

0 komentar:

Post a Comment

please comment for an article on a blog entry http://toyotavanza.com. everything abaout avanzaku